Notes
Slide Show
Outline
1
Build A PIC Microcontroller
  • EET 250
2
End Goal
3
End Goal
4
Assembly Steps
  • Simple PIC 16F917 40 PIN dip  ( notch on left)
    • Insert as shown
  • Power and Ground
      • +5V PINS 11, 32
      • GND PINS 12,31
      • Add .1UF cap between 11,12
      • Add .1 UF cap between 32,31
      • Jumper to +5V buss top to bottom
      • Jumper to GND Bus top to bottom
  • ICPD ( In Circuit Programmer Debug ) Interface for use with PICKIT2
    •  ( see attached schematic)
    • Use supplied 6 pin header
  • Single resistor /LED
    • !K with Red Led
    •  hooked to PORTD RD0
  •  Test with Blink Code
    • Open blink.mcp
    • Select PICKUT2
    • Make sure
5
Close-up
6
40 PIN DIP
7
In Circuit Programmer/Debug
8
Details